Skip to main content
All CollectionsTreatment Administration GuideWeight Loss
How to Inject Lipotropic (MIC) + B12
How to Inject Lipotropic (MIC) + B12
Updated over 2 weeks ago

⚠️ Important Note:

Prioritize safety when administering injections at home. Ideally, a healthcare professional should administer the injection. Self-administration should only be done under the guidance and approval of your healthcare provider. Always follow your healthcare provider’s instructions when taking your prescription.

A Guide on Self-Administering Lipotropic (MIC) + B12

This quick guide provides step-by-step instructions for self-administering Lipotropic (MIC) + B12 via injection. It covers essential preparation, syringe handling, and injection techniques to ensure a safe and effective experience. Follow these steps to properly administer Lipotropic (MIC) + B12 and care for the injection site afterward.

Getting Ready to Use

  1. Wash your hands thoroughly with soap and warm water to ensure cleanliness before handling supplies.

  2. Gather your supplies. This will include your MIC + B12 Injection, a new syringe or needle, and alcohol pads.

  3. Choose your injection site. Intramuscular injections are commonly done in the following areas:

    • Shoulder muscle (Deltoid)

    • Outer thigh muscle (Vastus lateralis)

    • Hip muscle (Ventrogluteal area)

    • Upper buttock muscles (Dorsogluteal area)

  4. Clean the selected injection site with an alcohol pad and let it air dry.

Preparing the Syringe

  1. Remove the cap from the Lipotropic (MIC) + B12 Injection vial.

  2. Clean the vial’s rubber stopper with a fresh alcohol pad.

  3. Draw air into the syringe equal to the amount of Lipotropic (MIC) + B12 Injection you plan to use.

  4. Insert the needle into the vial and push the plunger to inject the air, equalizing pressure.

  5. Invert the vial so the needle remains submerged in the fluid.

  6. Draw the desired amount of Lipotropic (MIC) + B12 Injection into the syringe.

  7. Tap the syringe gently to move any air bubbles to the top. Press the plunger slightly to expel the bubbles.

Administering the Injection

  1. Pinch your skin at the chosen injection site.

  2. Hold the syringe like a dart and insert the needle into the skin at a 45–90° angle.

  3. Release the pinched skin once the needle is inserted, then slowly depress the plunger to inject the Lipotropic (MIC) + B12 solution.

  4. Remove the needle from the skin.

  5. Discard the used syringe and needle in a sharps container for proper disposal.

⚠️ Important Note: Never reuse or share needles.

Providing Aftercare

  • Apply a bandage to the injection site if needed.

  • If you experience any adverse reactions—such as nausea, vomiting, rapid heartbeat, or difficulty breathing—seek medical attention immediately.

Did this answer your question?