Skip to main content
How to Inject Glutathione
Updated over 2 months ago

⚠️ Important Note:

Prioritize safety when administering injections at home. Ideally, a healthcare professional should administer the injection. Self-administration should only be done under the guidance and approval of your healthcare provider. Always follow your healthcare provider's instructions for taking your prescription.

A Guide to Using Glutathione Injection

This quick guide provides step-by-step instructions for injecting Glutathione. It covers essential preparation, syringe handling, and injection techniques to ensure a safe and effective experience. Follow these simple steps to properly administer Glutathione and care for the injection site afterward.


Getting Ready to Use

  1. Wash your hands thoroughly with soap and warm water to ensure cleanliness before handling supplies.

  2. Gather your supplies. This will typically include your Glutathione solution, a new syringe or needle, and alcohol pads.

  3. Choose your injection site. For subcutaneous injections, common areas include:

    • The abdomen (avoid the 2-inch area directly around the belly button)

    • The thigh

    • The upper arm

  4. Clean your preferred injection site with an alcohol pad and let it air dry.


Preparing the Syringe

To prepare your syringe for administering the Glutathione, follow these quick steps:

  1. Remove the cap from the Glutathione vial.

  2. Clean the rubber stopper on the vial with a new alcohol pad.

  3. Draw air into the syringe equal to the amount of Glutathione needed; this helps equalize pressure in the vial.

  4. Insert the needle into the vial and push the plunger to inject the air.

  5. Invert the vial with the needle inside so the needle remains below the fluid level.

  6. Draw the desired amount of Glutathione into the syringe.

  7. Remove air bubbles by gently tapping the syringe so the bubbles rise to the top, then press the plunger slightly until the bubbles are gone.


Administering the Injection

Once you are done preparing the syringe, you may now proceed in administering the injection by following these steps:

  1. Pinch your skin at the chosen injection site.

  2. Hold the syringe like a dart and insert the needle into the skin at a 45–90° angle.

  3. Release the pinched skin once the needle is in, then slowly depress the plunger to inject the Glutathione.

  4. Remove the needle from the skin after the injection.

  5. Dispose of the used syringe and needle in a sharps container.

⚠️ Important Note: Never reuse or share needles.


Providing Aftercare

  • Apply a bandage to the injection site if needed.

  • If you experience any adverse reactions—such as nausea, vomiting, rapid heartbeat, or difficulty breathing—seek medical attention immediately.


Helpful Tip!

Consider watching an instructional video for a detailed demonstration of how to give yourself a subcutaneous injection.

Did this answer your question?